Technical data
Error
Code
#20
Error
Code
#21
Error
Code
#22
Error
Code
#23
9030/40 Diagnostics
5-3
BAD
RTC:
NNNNN
BAD
RTC:
SELECT
CODE
NN
- Indicates that the built
in
Real Time Clock
is
not operating correctly.
BAD
SP:
SELECT
CODE
NN
- Indicates that the HP 9030 and HP
9040
computer's
service processor failed self-test.
T
est
car
d f 0
un
d - (Not an error.)
Test
Module did not
find
SCM
HP-UX
4.0
Operating System
Error
Messages
Warning and
Error
Messages
C 1 0 C K
and
d
ate
not
set,
- This message indicates that either the contents of the
NVM
are not
valid at powerup or the clock has not been set since this condition was detected.
Possible causes: a
bad battery on the
SCM board, or computer powered down
for
more than 2 weeks. The condition
does not stop the system operation.
Self
test
error
1:
liD
address
AA,
SS
STATUS:
XXXXXXXX
Where:
AA
= Select code
SS = Subaddress
XXXXXXXX
= Device or card dependent error information
(in
hexadecimal).
This error message
is
displayed as a result of the self-test failure of an
110
device. The select code
sub address denote the device, and the device dependent error information indicates the nature of
the failure. System operation can continue provided that use of the failed device
is
not required.
Se
1 f t
est
e r
ro
r 2:
CHECKSUM
for
s e
~Men
t
NN
- When the system
is
powered up,
or
a system
reset
is
executed, the checksum for every code segment
of
the operating system
is
computed and
compared to a checksum
in
the operating system code. When the checksums do not agree for a
segment, the segment number
is
stored.
As
a result, the segment reported
is
the last segment for
which a checksum error was detected. The operation
of
the system
is
not halted, however, further
operation
is
at your own
risk.
Self
test
error
3:
XXX
X
NN
Where:
XXXX
=
"CPU#",
"IOP#",
or "MC#_".
NN
= The Nth of that type of component (counting from the bottom of the stack).
This error occurs when the system
is
able to get completely through the board self-test
and
the
loader self-test, but a failed stack component
is
detected by the operating system. The message
indicates the type of component which has failed and
its
relative position
in
the stack. Operation of
the system can continue,
if
the failed board
is
not required,