Technical data

ManualsBrandsHP ManualsComputer equipment9030 CE

5-2

9030/40 Diagnostics

Error

Code

Error

Code

Error

Code

#11

BAD

CARD

DEVICE:

NNNNN

BAD

CARD

DEVICE:

SELECT

CODE

- Informational message. A hardware failure has been detected (interface card or

mass storage device did not pass the Module Self-Test). The loader continues

searching for an operating system.

Possible causes: bad interface card or mass

storage device.

DEVICE

NOT

READY:

NNNNN

VOLUME

NOT

MOUNTED:

NNNNN

MEDIA/DEVICE

NOT

READY:

SELECT

CODE

- While loading, the media (Volume) was removed from the device (e.g. a floppy

disc was pulled out of a disc drive), the device went offline, or a hardware problem

caused the device to become

"not

ready".

DMA

LED:

NNNNN

- Data did not transfer properly from the mass storage device

to the computer.

Possible cause:

Mass

storage device hardware failure or computer

hardware failure.

UNRECOVERABLE

DATA:

NNNNN

UNRECOVERABLE

DATA:

SELECT

CODE

- Part of the operating system

not readable. Possible causes: media failure or

mass storage device hardware failure.

Error

Code

END

IjOLUME:

NNNNN

# 12

END

VOLUME:

SELECT

CODE

Error

Code

#13

Error

Code

#14

Error

Code

#15

Error

Code

#16

Error

Code

#17

Error

Code

#18

Error

Code

#19

- Attempt to address or read past the end of a volume. Possible causes: corrupt

system, media failure or mass storage device hardware failure.

CTRLR/UNIT

FAULT:

NNNNN

CTRLR/UNIT

FAULT:

SELECT

CODE

- Hardware passed

initial

self-test. However.

failed while being used to load the

operating system.

Possible causes: computer (interface card) hardware failure or

mass storage device hardware failure.

TIMEOUT:

NNNNN

TIMEOUT:

SELECT

CODE

- Mass storage device failed to respond

fast

enough while attempting to load from

it.

Possible cause: computer hardware failure or mass storage device hardware

failure.

CSSO

DEVICE:

NNNNN

CSSO

DEVICE:

SELECT

CODE

- Indicates a mass storage device hardware failure.

TAPE

DEVICE:

SELECT

CODE

-Usually indicates a tape device (HP 7970,

7974, HP 7978) hardware failure. Can also indicate a failure on the HP 27110A

HP-IB Interface (or the Internal HP-IB interface). Tape errors covered are: "Com-

mand Rejected", "Interface Busy", "Rewinding", "Tape Runaway", "Data Timing

Error",

and

"Command Parity Error".

HPIB

CARD:

NNNNN

HPIB

CARD:

SELECT

CODE

- Transaction to the indicated HPIB interface card was terminated due to a prob-

able interface card failure.

BAD

BUS:

NNNNN

BAD

BUS:

SELECT

COOE

- Indicates a computer hardware failure on the computers

first

lOP.

BAD

NI)M:

NNNNN

BAD

NVM:

SELECT

CODE

- Indicates that Non-Volatile Memory failed

its

self-test. Possible cause: computer

hardware failure.