Technical data
9020/9030/9040 Environmental/Installation/PM 2-17
8.
(520)
Close the left side door.
(530/540)
Replace the
RFI
shield.
9.
(520)
Remove right side door.
(530/540)
Remove the top cover of the System
II
enclosure. The cover has
one
captive screw at the
back of the box. Loosen the screw
and
slide the cover back
and
away from the box.
10.
(530/540 ONLY)
Disconnect the ac module cable
and
the service module cable.
11.
(520)
Remove three
#2
Pozidriv screws from the mass storage cover (Figure
1).
(530/540)
Remove the four
#2
Pozidriv screws that attach the
110
lid.
Remove the
lid.
MASS STORAGE COVER *
1/0 DOOR
12.
(520 ONLY)
*
#2
POZIDRIV MASS STORAGE COVER SCREW
*
110
DOOR CAPTIVE THUMB SCREW
Figure
1.
Removing
Mass
Storage
Cover
*
*
Loosen two captive thumbscrews
on
I/O door (Figure
1)
and
swing door open, allowing
door
to rest
in
open
position.
13.
(520 ONLY)
Slide mass storage cover towards front cover of computer, disengaging cover from slot
in
front card
gUide.
14.
(520 ONLY)
Lift
mass storage cover with attached
110
door up and away from computer.