Technical data

2-12 902090309040 Environmental Installation PM
Figure 6. Plastic lOP Connector Cover.
16. (530/540 ONLY)
Route cable between terminal block and base plate into enclosure.
17. (530/540 ONLY)
Remove cover plate from appropriate lOP expander slot in the computer rear panel. Insert
lOP cable connector into the appropriate slot and secure in place with two nuts on the
posts: (slots viewed from rear.)
(530 - 2nd lOP) Upper slot.
(530 - 3rd lOP) Lower slot.
(540 - 2nd lOP) Right slot.
(540 - 3rd lOP) Left slot.
CAUTION
ENSURE THE LO EXPANDER CONNECTOR ON THE PROCESSOR
STACK DOOR IS COVERED TO PREVENT RFI RADIATION.
18. (530,540 ONLY)
Attach 110 expander cable to connector on rear panel, or cover connector with plastic
connector cover.
19. (520 - 2nd lOP)
Replace the trim piece and the left door.
(520 - 3rd lOP)
Close the left door.
(530)
Replace RFI shield. top and bottom covers of System II enclosure. and front panel.
(540)
Replace RFI shield. top and bottom covers of System II enclosure. front panels and flip top
cover.
20. (ALL)
Plug the power cord into the ac outlet and switch on the power.