Technical data

2-10 9020/9030/9040 Environmenta[ilnstallation·PM
10. (520)
Place lOP
cable door connector over studs on ends of appropriate 110 EXPANDER
connector
slot. and tighten connector to door with two nuts (Figure 3):
(2nd
lOP) 1/0 EXPANDER 1 slot.
(3rd
lOP) \10 EXPANDER 2 slot.
(530/540)
Continue with step 12.
11.
(520 ONLY)
Install cable clamp on door so that it holds cable(s) in position (Figure 4).
CONNECTOR GATE
CABLE CLAMP
Figure 4. 520 Computer Stack Door.
12.
(520)
Connect the lOP cable finstrate connector to the lOP finstrate with cable pointing down.
Close the connector gate
and seat the finstrate into the motherboard connector (Figure 4).
(530
/
540)
Route lOP cable through base plate. Connect lOP cable fin strate connector to finstrate.
Close connector gate
and seat board into motherboard connector.
13.
(ALL EXCEPT 520 - 3rd lOP)
Install processor stack door with two captive #2 Pozidriv screws at bottom.
(520 - 3rd lOP)
Continue with next step.