Technical data

2-2 9030/40 Environmental/Installation/PM
Installation Procedure
1. Unpack the computer.
2. Position the computer. Leave about 6 inches of space at each side of computer (9030) or 6
inches at back
(9040).
3. Connect power cord to power source.
Q),
~
~
E
[JLJ
••
L N
Australia
South
Africa
Country
Australia
Denmark
Europe
Great Britain
Switzerland
United States
United States
Denmark
~
~
Europe
Switzerland
United States
120V
PIN
09855-61601
09855-61606
09855-61602
09855-61605
09855-61604
09855-61600
09855-61603
Opt.
901
912
902
900
906
903
904
Great Britain
Q
-
L N
E
•
United States
240V
Voltage
250V,6A
250V,6A
250V, 6A
250V, 6A
250V,6A
110V,10A
220V,10A
NOTE: Plugs are viewed from connector end. Shape of molded plug may vary within country.
Power cords supplied by HP have polarities matched
to the power-input socket on the computer:
• L = Line or Active Conductor (also called "live" or "hot")
•
N = Neutral or Identified Conductor
• E = Earth or Safety Ground
4. Check switch settings of interface cards (Chapter 7).
5. Install interface cards and connect the cables.
a. System Terminal (console) Interface Card in slot O.
b. System Disc HP-IB in slot 5.
6. Check the switches on the peripheral devices.
a. Terminals
LocalEcho:
OFF
Xmit Pace: XON/XOFF
CapsLock:
OFF
Line Block Mode: Line
XmitFnctn(A):
NO
Return Def:
CR
InhHndShk(G):
YES
Remote*:
ON
InhD2(H): YES
Auto
LF: OFF
BaudRate:
9600
Display Function:
OFF
Bits/Character: 8
Parity:
None
EnqAck:
YES
RecvPace:
XON/XOFF
b. Disc Drives
Set HP-IB address switch for system disc drive to "0".