Installation guide

Chapter 2

Installing the Server

Cabling and Power Up

Step 10. A screen similar to the following is displayed, allowing verification of the settings:

Figure 2-32 The ls Command Screen

Step 11. To return to the MP main menu, enter ma.

Step 12. To exit the MP, enter x at the MP main menu.

Accessing the Management Processor via a Web Browser

Web browser access is an embedded feature of the MP/SCSI card. The Web browser enables access to the

server through the LAN port on the core I/O card. MP configuration must be done from an ASCII console

connected to the Local RS232 port..

NOTE The MP/SCSI card has a separate LAN port from the system LAN port. It requires a separate

LAN drop, IP address, and networking information from that of the port used by HP-UX.

Before starting this procedure, the following information is required:

• IP address for the MP LAN

• Subnet mask

• Gateway address

• Host name (this is used when messages are logged or printed)

To configure the LAN port for a Web browser, perform the following steps:

Step 1. Connect to the MP using a serial connection.

Step 2. Configure the MP LAN. Refer to “Configuring LAN Information for the MP”.

Step 3. Type CM to enter the Command Menu.