Installation guide

Chapter 2

Installing the Server

Lifting the Server Cabinet Manually

Use this procedure only if no HP approved lift is available.

CAUTION This procedure must only be performed by four qualified HP Service Personnel utilizing proper

lifting techniques and procedures.

CAUTION Observe all electrostatic discharge (ESD) safety precautions before attempting this procedure.

Failure to follow ESD safety precautions can result in damage to the server.

Step 1. Follow the instructions on the outside of the service packaging to remove the banding and

cardboard top from the server pallet.

Step 2. Reduce the weight by removing the bulk power supplies and cell boards. Place each on an ESD

approved surface.

CAUTION System damage can occur through improper removal and reinstallation of bulk

power supplies and cell boards.

Step 3. Remove the systems left and right side covers.

NOTE The latest lift handles available for the 2-cell servers are symmetrical and can be

installed on either side of the server.

Step 4. Locate one handle and ensure the two thumbscrews are removed from its front flange.