Technical data

Using Console and Service Processor Interfaces
Using Service Processor Commands
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
99
Using Service Processor Commands
You can issue commands at the service processor Command menu.
To access the service processor Command menu, enter CM at the service
processor’s Main menu. To exit the Command menu, enter the MA
command to return to the Main menu.
All service processor users accessing the Command menu share access to
the menu.
Only one command can be issued at a time. For each command issued,
the command and its output are displayed to all users currently
accessing the Command menu.
Some commands are restricted and are available only to users who have
Administrator or Operator privileges. You can issue any command that is
valid at your access level by entering the command at the Command
menu prompt (GSP:CM> or MP:CM>).
When you list commands using the HE command, the commands are
shown in the following categories:
• Service commands—Support boot, reset, TOC, and other common
service activities.
• Status commands—Give command help and system status
information.
• System and access configuration commands—Provide ways to
configure system security and console and diagnostic settings.
The following sections give more details about the available commands.
HP Restricted / DRAFT
DRAFT NOV 2001