Technical data

Using Console and Service Processor Interfaces
Procedure: Logging in to a Service Processor
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
94
All telnet commands and escape options are supported while you are
connected to the service processor. See the telnet(1) manpage for details.
(On non-HP-UX platforms such as various PC environments you can
instead use an alternate telnet program.)
Step 2. Log in using your service processor user account name and password.
GSP login: Accountname
GSP password: Password
Step 3. Use the service processor menus and commands as needed and log out
when done.
To log out, select the Exit Connection menu item from the Main menu
(enter X at the GSP> prompt or MP> prompt).
You also can terminate a login session by issuing the telnet escape key
sequence ^] (type: Control-right bracket) and entering close at the
telnet> prompt.
NOTE If possible you should log out of any consoles and menus before
terminating your telnet session.
If accessing HP-UX on an nPartition, log out of HP-UX before exiting the
console and service processor sessions. (Otherwise an open HP-UX login
session will remain available to any other service processor users.)
HP Restricted / DRAFT
DRAFT NOV 2001