Technical data

Introduction to nPartitions
parmodify Command
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
78
-m cell:[cell_type]:[use_on_next_boot]:[failure_usage]
Modify attributes of a cell already assigned the
partition.
For details on cell_type, use_on_next_boot, and
failure_usage see the -a option’s descriptions (above).
-I IPaddress Specifies the IP address that should be used by
management tools (like SAM) to address this partition.
-r cell Specifies the core cell and core alternate cells. One to
four core cell choices can be specified.
-d cell Remove the specified cell from the partition.
-b path Specifies the primary (PRI) boot path.
-t path Specifies the alternate (ALT) boot path.
-s path Specifies the secondary (HAA) boot path.
-P PartitionName Specifies the name of the partition.
-B Specifies whether to boot the partition. The default is
not to boot.
When you specify the -B option when modifying an
inactive nPartition, the partition is booted (and
becomes active) when it is modified.
When you specify the -B option when modifying an
active nPartition, you must perform a
reboot for reconfig of the modified partition. You must
perform this reboot for reconfig before any other cell
assignments can take place in the server complex.
HP Restricted / DRAFT
DRAFT NOV 2001