Technical data

Introduction to nPartitions
Using HP-UX nPartition Configuration Commands
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
69
Table 2-2 describes the nPartition configuration commands and lists
sections where you can find each command’s syntax and details.
Table 2-2 HP-UX nPartition Configuration Commands
Command Description
parcreate Create a new partition; root permission is required.
See parcreate Command on page 76.
parmodify Modify an existing partition; root permission is required.
See parmodify Command on page 77.
parremove Remove an existing partition; root permission is required.
See parremove Command on page 79.
parstatus Display partition information and hardware details for a server
complex.
See parstatus Command on page 80.
parunlock Unlock Complex Profile data (use this command with caution); root
permission is required.
See parunlock Command on page 82.
fruled Blink the attention indicators (LEDs) or turn them off. This command
can control these indicators for cells, I/O chassis, and cabinet numbers.
See the fruled (1) manpage for details.
frupower Display status or turn power on or off for cells and I/O chassis; root
permission is required.
See the frupower (1M) manpage for details.
HP Restricted / DRAFT
DRAFT NOV 2001