Technical data

Introduction to nPartitions
Using HP-UX nPartition Configuration Commands
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
68
Using HP-UX nPartition
Configuration Commands
HP-UX 11i provides you with several HP-UX commands for configuring
and managing nPartitions and related server hardware.
The nPartition commands include: parcreate, parmodify, parremove,
parstatus, parunlock, fruled, and frupower. Table 2-2 on page 69
describes each of these commands.
Using these commands you can create, modify, monitor, and remove
nPartitions; get detailed server hardware information; and manipulate
attention indicators (LEDs) and power.
When using these commands, you can specify cells and I/O chassis with
the notations shown in Specifying Cells and I/O Chassis to Commands
on page 70.
NOTE The HP-UX nPartition configuration commands are supported only on
HP servers that support nPartitions.
These commands are supported by HP-UX kernels built with nPartition
support enabled (the hd_fabric driver), and they use the libfab.1 library.
HP Restricted / DRAFT
DRAFT NOV 2001