Technical data
Introduction to nPartitions
Process for Selecting Cells for nPartitions
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—schwartz@rsn.hp.com
56
will cause the partition to wait 10 minutes for the cell during the
partition boot process, if the cell has a “y” use-on-next-boot setting.
If any of the cells does not adhere to these requirements, go back to
Step 3 and select a different set of cells for the partition.
Step 5. Assign the cells to the partition.
You can either create a new partition that includes the selected cells, or
you can modify an existing partition so that it conforms to the partition
configuration recommended by the configuration chart.
For specific steps for assigning cells, refer to the procedure for creating
an nPartition or the procedure for adding cells to an nPartition.
Step 6. If you still have additional nPartitions for which to select and assign
cells, continue with Step 2.
Select the largest remaining undefined nPartition, and go back to Step 2
to choose and assign cells for it.
HP Restricted / DRAFT
DRAFT NOV 2001