Technical data

Listing and Managing Server Hardware
Listing the nPartitions in a Server
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
294
Listing the nPartitions in a Server
You can list details about the nPartitions defined in a server complex,
including the partition numbers, partition names, and the cells assigned
to the partitions.
You can perform this procedure using the following methods:
• Service Processor (GSP or MP) on page 294
This procedure (Command menu, CP command) lists all nPartitions
using the service processor.
• HP-UX Commands on page 295
This procedure (parstatus -P) lists a server’s nPartitions from HP-UX.
• Partition Manager on page 295
This procedure (viewing the left side of the primary window) displays
all nPartitions in the server using Partition Manager.
Service Processor
(GSP or MP)
This procedure (Command menu, CP command) lists all nPartitions
using the service processor.
Step 1. Log in to the server’s service processor and enter CM to access the
Command menu.
Step 2. Issue the service processor Command menu’s CP command to list all
nPartitions defined in the server complex.
The CP command lists the partition number (Part 0, Part 1, and so on) for
each partition and lists which cells are assigned to each partition.
GSP:CM> CP
--------------
Cabinet | 0 |
--------+----+
Slot |0123|
--------+----+
Part 0 |*...|
Part 1 |.*..|
GSP:CM>
HP Restricted / DRAFT
DRAFT NOV 2001