Technical data

Listing and Managing Server Hardware
Listing the Cabinets in a Server Complex
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
292
Listing the Cabinets in a Server Complex
You can list all cabinets in a server complex by using software commands
and utilities, which allow you to determine the complex’s cabinet
configuration from a remote location.
You can perform this procedure using the following methods:
• Service Processor (GSP or MP) on page 292
This procedure (Command menu, DU command) lists all cabinets in
the server complex using the service processor.
• HP-UX Commands on page 293
This procedure (parstatus -B or parstatus -V -b#) lists cabinet details
from HP-UX.
• Partition Manager on page 293
This procedure (Complex —> Show Complex Details menu, Cabinet
Info panel) lists the cabinets in a server complex from Partition
Manager.
Service Processor
(GSP or MP)
This procedure (Command menu, DU command) lists all cabinets in the
server complex using the service processor.
Step 1. Log in to the server’s service processor and enter CM to access the
Command menu.
Step 2. Issue the DU command to list all cabinets in the server complex.
GSP:CM> DU
The following GSP bus devices were found:
+----+-----+-----------+----------------+-----------------------------------+
| | | | | Core IOs |
| | | | | IO Bay | IO Bay | IO Bay | IO Bay |
| | | UGUY | Cells | 0 | 1 | 2 | 3 |
|Cab.| | | |IO Chas.|IO Chas.|IO Chas.|IO Chas.|
| # | GSP | CLU | PM |0 1 2 3 4 5 6 7 |0 1 2 3 |0 1 2 3 |0 1 2 3 |0 1 2 3 |
+----+-----+-----+-----+----------------+--------+--------+--------+--------+
| 0 | * | * | * |* * * * | * | * | | |
| 1 | | * | * |* * * | | * | | |
| 8 | | * | * | | * | * | | |
GSP:CM>
HP Restricted / DRAFT
DRAFT NOV 2001