Technical data

Listing and Managing Server Hardware
Listing Cell Processor and Memory Configurations
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
276
The PS command reports details for the cell including its processor
configuration (CPU population) and its memory configuration (DIMM
population).
For the cell memory configuration details, the PS command displays each
populated DIMM and identifies it using its rank notation (0A–0D,
1A–1D, and so on).
The following example shows details for cell 0 in cabinet 0, which has
four processors (0–3) and four DIMMs installed (0A–0D).
BCH This procedure (Information menu, PR and ME commands) lists cell
processor and memory configurations from a partition’s BCH interface.
GSP:CM> PS
This command displays detailed power and hardware configuration status.
You may display detailed power and hardware status for the following items:
B - Cabinet (UGUY)
C - Cell
G - GSP
I - Core IO
Select Device: c
Enter cabinet number: 0
Enter slot number: 0
HW status for Cell 0 in cabinet 0: NO FAILURE DETECTED
Power status: on, no fault
Boot is not blocked; PDH memory is shared
Cell Attention LED is off
RIO cable status: connected
RIO cable connection physical location: cabinet 0, IO bay 1, IO chassis 3
Core cell is cabinet 0, cell 0
PDH status LEDs: ****
CPUs
0 1 2 3
Populated * * * *
Over temperature
DIMMs populated:
+----- A -----+ +----- B -----+ +----- C -----+ +----- D -----+
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
* * * *
PDC firmware rev 10.0
PDH controller firmware rev 7.6, time stamp: TUE MAY 08 20:42:26 2001
GSP:CM>
HP Restricted / DRAFT
DRAFT NOV 2001