Technical data

Procedures for Managing nPartitions
Setting and Checking Cell Attributes
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
239
Step 1. Run Partition Manager (/opt/parmgr/bin/parmgr) or access it from
SAM or a Web browser.
Step 2. In the Partition Manager primary window, select the nPartition whose
cell attributes you want to change.
Click the partition’s name in the list on the left side of the primary
window to select the nPartition.
Step 3. Select the Partition —> Modify Partition action, and click the Change Cell
Attributes
tab.
Step 4. Highlight the cell whose attributes you want to modify, click the Modify
Cell
button, and configure the cell attributes as desired.
You can modify the settings for multiple cells at once by selecting all
desired cells (press Control while clicking on the cells) before clicking the
Modify Cell button.
Configure the cell attributes in the window, and then click OK to apply
the modified attributes or Cancel to cancel any changes.
Step 5. If you have modified any cell attributes, when you return to the Change
Cell Attributes
tab you can click OK to apply the changes or click Cancel to
cancel them.
Review any Notes and Warnings that Partition Manager presents, then
click OK to proceed or Cancel to cancel the changes.
If the cell attribute changes are implemented, Partition Manager
presents a final confirmation that the partition was successfully
modified.
Step 6. If you have modified a cell’s attribute settings, for the settings to be used
you must reboot the partition to which the cell is assigned.
Rebooting the cell’s partition allows the partition to use each cell’s new
attribute settings.
HP Restricted / DRAFT
DRAFT NOV 2001