Technical data

Procedures for Managing nPartitions
Removing Cells from an nPartition
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
223
• When a reboot for reconfig is required, the Notes and Warnings tab
also has a check box (“Automatically boot partition”) that—when
selected—enables the partition to rendezvous and be active after the
reboot for reconfig.
To cancel all partition changes, click the Cancel button in the Notes and
Warnings window and then click Cancel in the Modify Partition window.
To proceed with removing the cell(s) from the partition, click OK.
Step 8. When Partition Manager confirms that the “partition has been
successfully modified” review any additional information and respond as
needed to the dialog box presented.
(The cells were designated to be removed from the nPartition after
completing the previous step, however a reboot may be required.)
• If you have removed only inactive cells from the nPartition, Partition
Manager provides no additional info and you can click OK to complete
the procedure (a reboot is not needed).
• If you have removed one or more active cells from the nPartition, then
Partition Manager provides more info about performing the required
reboot for reconfig of the partition.
You must reboot the nPartition as soon as possible, so you should
click the Yes button to exit Partition Manager and proceed with the
next step of this procedure.
HP Restricted / DRAFT
DRAFT NOV 2001