Technical data

Procedures for Managing nPartitions
Removing Cells from an nPartition
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
222
Step 4. In the Modify Partition window, click the Add/Remove Cells tab.
Step 5. Select the cells that you want to remove from the nPartition from the
“Cells in the Partition” list, then click the Remove button to move them to
the Available Cells list. If removing multiple cells, you can select
multiple cells by pressing the Control key while clicking on the cells.
Removing the cell(s) from the partition should create a configuration
that adheres to the hardware requirements and performance guidelines.
Step 6. After you have removed the cells from the partition’s cell list, click the
OK button.
The cells are not actually removed from the partition until after the next
step.
Step 7. Review the information shown in the Notes and Warnings, the Summary of
Changes
, and the HA Checks tabs.
Partition Manager generates this information when it checks details of
the new partition configuration.
If you must perform a reboot for reconfig of the nPartition, such as when
removing an active cell from the partition, then the Notes and Warnings
tab provides details and options.
• If a reboot for reconfig is required, the Notes and Warnings tab has
information about the reboot procedure. (See Step 9 for details.)
HP Restricted / DRAFT
DRAFT NOV 2001