Technical data

Procedures for Booting and Resetting nPartitions
Configuring Fast Boot Settings (Self Tests) for a nPartition
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
193
NOTE HP recommends that all self tests be performed for all nPartitions.
To enable all tests for a partition, use the following command:
setboot -t all=on
For example, to enable the early CPU tests and PDH tests but disable
the late CPU tests issue the following command:
setboot -t early_cpu=on -t PDH=on -t late_cpu=off
This changes the local nPartition’s settings for these tests in its stable
storage and uses these test configurations for all following boots.
After modifying an nPartition’s self test configuration you can list the
new settings with the setboot -v command.
For more details refer to the setboot (1M) manpage.
HP Restricted / DRAFT
DRAFT NOV 2001