Technical data

Procedures for Booting and Resetting nPartitions
Autostart Configuration
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
186
NOTE This procedure applies to nPartitions on HP Superdome servers only.
Step 1. Log in to the Superdome complex’s service processor (GSP), access the
nPartition’s console, and access the BCH Configuration menu.
From the nPartition console you can access the partition’s BCH interface.
If the partition is not at the BCH interface you must either boot the
partition or shut down HP-UX to return to the BCH interface.
From the BCH Main menu, enter CO to access the Configuration menu.
Step 2. From the BCH Configuration menu, use the AU command to list or set
Autostart for the partition.
Enter AU with no arguments to list the Autostart setting.
Enter AU ON to set Autostart to ON, or AU OFF to set it to OFF.
HP Restricted / DRAFT
DRAFT NOV 2001