Technical data

Procedures for Booting and Resetting nPartitions
Listing nPartition Boot Settings
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
175
• BCH Information menu
From the BCH Main menu, enter IN to access the Information menu.
Step 3. At the appropriate BCH menu issue the command to display the boot
information of interest to you.
See the list in the previous step for commands and menus. Enter the
command with no arguments to display (but not change) the boot setting.
The following example shows using the PATH command to list the
partition’s boot paths, then accessing the BCH Configuration menu and
issuing the PATHFLAGS command to list the partition’s boot action
settings for the PRI, HAA, and ALT boot paths.
Table 5-3 BCH Information Menu Boot Settings
BOOTINFO Displays boot configuration information.
Main Menu: Enter command or menu > PATH
Primary Boot Path: 4/0/2/0/0.10
4/0/2/0/0.a (hex)
HA Alternate Boot Path: 4/0/1/0/0.6
4/0/1/0/0.6 (hex)
Alternate Boot Path: 4/0/1/0/0.5
4/0/1/0/0.5 (hex)
Main Menu: Enter command or menu > CO
---- Configuration Menu ------------------------------------------------------
Command Description
------- -----------
AUtostart [ON|OFF] Display or set the auto start flag
BootID [<cell>[<proc>[<bootid>]]] Display or set Boot Identifier
BootTimer [0-200] Seconds allowed for boot attempt
Configuration Menu: Enter command > PATHFLAGS
Primary Boot Path Action
Boot Actions: Boot from this path.
If unsuccessful, go to next path.
HA Alternate Boot Path Action
Boot Actions: Boot from this path.
If unsuccessful, go to BCH.
Alternate Boot Path Action
Boot Actions: Skip this path.
Go to BCH.
Configuration Menu: Enter command >
HP Restricted / DRAFT
DRAFT NOV 2001