Technical data

Procedures for Booting and Resetting nPartitions
Listing nPartition Boot Settings
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
173
Listing nPartition Boot Settings
You can list an nPartition’s boot-related settings by using the partition’s
BCH interface or by using HP-UX commands.
To list boot settings for nPartitions you can use the following methods:
• BCH on page 173
This procedure (Main menu, Information menu, and Configuration
menu BCH commands) lists a partition’s boot settings using the BCH
interface.
• HP-UX on page 176
This procedure (parstatus -V -p# and setboot commands) lists an
nPartition’s boot settings using HP-UX commands.
• Partition Manager on page 178
This procedure (Partition —> Show Partition Details action, General
tab) lists an nPartition’s boot paths from Partition Manager.
Also refer to the following sections for details on configuring boot settings
for nPartitions.
• “Configuring Boot Paths for a Partition”
• “Configuring Boot Actions for Partition Boot Paths”
• “Configuring Auto Start for a Partition”
• “Configuring Fast Boot Settings for a Partition”
• “Configuring the Boot Timer for a Partition”
• “Deconfiguring Cells, Processors, and Memory”
BCH This procedure (Main menu, Information menu, and Configuration menu
BCH commands) lists a partition’s boot settings using the BCH interface.
Step 1. Log in to the server complex’s service processor (GSP or MP), access the
partition’s console, and access the BCH Main menu.
HP Restricted / DRAFT
DRAFT NOV 2001