Technical data

Using Console and Service Processor Interfaces
Configuring Service Processor Network Settings
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
108
After you reconfigure the service processor’s networking, you can remove
these network routing table changes with the route delete... command.
3. Enter this command to confirm the new network connection to the
service processor: ping 198.168.1.1 -n 2
4. Use the telnet 192.168.1.1 command from the PC or workstation
to connect to the service processor.
Step 2. From the service processor Command menu, enter LS to list the current
network settings, and if needed use the LC command to reconfigure the
network settings for the service processor.
You must be logged in as an administrator to use the LC command.
The LC command enables you to modify the customer LAN and/or the
private LAN configuration.
You can cancel all changes to the service processor LAN configuration at
any time by replying Q to any of the LC command’s prompts.
HP Restricted / DRAFT
DRAFT NOV 2001