Technical data

Using Console and Service Processor Interfaces
Service Processor Commands: Quick Reference
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
103
System and Access Configuration Commands
The system and access configuration commands provide ways to
configure system security and console and diagnostic settings. These
commands also enable you to modify some complex configuration
settings. Some of these commands are restricted (users with an
“Operator” or “Single Partition User” access level can issue a subset of
these commands).
Table 3-4 Service Processor: System and Access Configuration Commands
Access Level(s) Command Description
Administrator AR Configure the automatic system restart for an
nPartition.
Administrator,
Operator
CA Configure asynchronous and modem parameters.
Administrator,
Operator
CC Initiate a complex configuration.
Administrator DATE Set the time and date.
Administrator DC Reset parameters to default configuration.
Administrator,
Operator
DI Disconnect remote or LAN console.
Administrator DL Disable LAN console access.
Administrator EL Enable LAN console access.
Administrator,
Operator,
Single Partition
User
ER Configure remote/modem port access options.
Administrator,
Operator
FW Firmware update utility. (HP rp8400 and HP rp7410
servers only.)
Administrator,
Operator,
Single Partition
User
ID Display and/or change certain Stable Complex
Configuration Data fields, which describe the complex
identity.
Administrator IF Display network interface information.
HP Restricted / DRAFT
DRAFT NOV 2001