Technical data

Using Console and Service Processor Interfaces
Commonly Used Service Processor Commands
HP System Partitions Guide: Administration for nPartitions—rp7410
EMSP—[e-mail]
100
Commonly Used Service Processor Commands
Table 3-1 summarizes commands that are commonly used by system
administrators. These commands are available to all service processor
users.
The above commonly used commands appear in the service, status, and
the system and access configuration categories.
For additional commands, by category, see the following sections.
Table 3-1 Commonly Used Service Processor Commands
Command Description
BO Boot an nPartition past an inactive boot-is-blocked
(BIB) state to make it active.
CP Display nPartition cell assignments.
HE Help: list the available commands.
LS Display LAN connected console status.
MA Return to the service processor Main menu.
PD Set the default nPartition for the current session.
PS Display detailed power and hardware configuration
status.
RS Reset an nPartition.
RR Reset an nPartition to a ready for reconfiguration state,
which makes the nPar inactive.
SYSREV Display all cabinet FPGA and firmware revisions.
(HP rp8400 and HP rp7410 only.)
TC Send a TOC signal to an nPartition.
TE Broadcast a message to all users of the Command
menu.
WHO List all users connected to the service processor.
HP Restricted / DRAFT
DRAFT NOV 2001