Installation guide

Chapter 4

Cabling and Power Up

Accessing the Management Processor via a Web Browser

Web browser access is an embedded feature of the MP/SCSI Core I/O card. The Web browser allows access to

the server through the LAN port on the core I/O card. Initial MP configuration must be done from the local

console connected to the Local RS232 port.

NOTE The MP/SCSI Core I/O card has a separate LAN port from the system LAN port. It requires a

separate LAN drop, IP address, and networking information from that of the port used by

HP-UX.

Before starting this procedure, the following information is required:

• IP address for the MP LAN

• Subnet mask

• Gateway address

• Host name (this is used when messages are logged or printed)

To configure the LAN port for a Web browser, perform the following steps:

Step 1. Connect to the MP/SCSI Core I/O using a serial connection.

Step 2. Configure the MP/SCSI Core I/O LAN. Refer to “Configuring LAN Information for the MP” on

page 55.

Step 3. Type CM to enter the Command Menu.

Step 4. Type sa at the MP:CM> prompt to display and set MP remote access.

Figure 4-10 Example sa Command

Step 5. Enter W to modify web access mode.

Step 6. Enter 2 to enable web access.