Installation guide

Chapter 3

Installing Accessories

PCI/PCI-X Card Cage Assembly I/O Cards

Step 1. Remove the top cover.

Step 2. Remove the PCI bulkhead filler panel.

Step 3. Lever open the Manual Retention Latch for selected slot. Refer to Figure 3-2.

Step 4. Install the I/O card in the slot.

NOTE A slow, firm pressure is needed to properly seat the card into the backplane.

Step 5. Flip the Manual Release Latch for the card slot to the closed position.

CAUTION Working out of sequence or not completing the actions within each step could cause

the system to crash.

Do not press the attention button until the latch is locked.

Step 6. Press the attention button.

The green power LED will start to blink.

Figure 3-2 PCI I/O Slot Details

Step 7. Wait for the green power LED to stop blinking and remain solid green.

Step 8. Check for errors in the hotplugd daemon log file (default: /var/adm/hotplugd.log).

Manual Release Latch Closed

Manual Release Latch Open

Power LED (Green)

Attention LED (Yellow)

Attention Button