Specifications

Chapter 3
Utilities
Management Processor (MP)
36
NOTE The host name is not case sensitive.
Step 7. The screen displays the current subnet mask name. When prompted to enter a new value or Q,
enter the new subnet mask name.
Step 8. The screen displays the current gateway address. When prompted to enter a new value or Q, enter
the new gateway address.
Step 9. The screen displays the current link state information. When prompted to enter a new value or Q,
press
enter. The message -> Current Link State has been retained displays.
Step 10. The screen displays the current Web console port number. When prompted to enter a new value or
Q, press
enter. The message -> Current Web Console Port Number has been retained
displays.
Step 11. The screen displays the current SSH console port number. When prompted to enter a new value or
Q, press
enter. The message -> Current SSH Console Port Number has been retained
displays.
NOTE SSH settings will not display if you do not have Integrated Lights-Out Advanced
Pack licensing.
Step 12. The screen displays a new LC listing, including the values entered in the preceding steps. Verify
that the desired values have been accepted. When prompted to enter a parameter for revision, Y to
confirm, or Q to Quit, enter Y to confirm all parameters.
> LAN Configuration has been updated
-> Reset MP (XD command option ‘R’) for configuration to take effect.
MP Host Name: mpserver
Step 13. Enter XD -reset to reset the MP.
Step 14. After the MP resets, log in to the MP again. Then enter the MP command mode (enter CM at the MP:
prompt).
Step 15. At the MP:CM> prompt, enter LS to confirm the new LAN settings.
Step 16. Enter SA to enable or disable Web console and telnet access after the MP has been reset.
The LC Command Screen
The following screen shows LC command output:
MP:CM> LC -nc
Current LAN Configuration:
MAC Address : 0x0060b0f54c51
DHCP Status : Enabled
IP Address : 127.1.1.1
MP Host Name : maestro
Subnet Mask : 255.255.248.0
Gateway Address : 127.1.1.1
Link State : Auto Negotiate