Specifications

Chapter 1

Controls, Ports, and Indicators

Rear Panel

10/100/1000 Base-T Ethernet LAN Connector

The rear panel 10/100/1000 base-T ethernet LAN connector has the following status and activity LEDs.

Figure 1-6 10/100/1000 Base-T Ethernet LAN Connector LEDs

Locator button and

LED

The locator button and LED are used to help locate a server within a rack of

servers. When the button is engaged, the blue LED illuminates and an additional

blue LED on the front panel of the server illuminates. This function may be

remotely activated.

Video (not used) 15-pin female video connector. DISABLED—DO NOT USE. To enable video

capability you must obtain the supported A6150 video PCI card. See enclosed

ReadMe, A6150-90001.

Console/remote/UPS 25-pin female serial data bus connector for the iLO manageability card.

10/100 MP LAN 10 Mb/100 Mb LAN connector for the management processor.

Table 1-5 10/100/1000 Base-T Ethernet LAN Connector LEDs

LED Description

1000BT Blinking green—the 1000 MHz with ethernet protocol and twisted-pair wiring is

enabled, off—no link.

100BT Blinking green—the 100 MHz with ethernet protocol and twisted-pair wiring is

enabled, off—no link.

10BT Blinking green—the 10 MHz with ethernet protocol and twisted-pair wiring is

enabled, off—no link.

Activity Blinking green—LAN activity.

Table 1-4 Rear Panel Connectors and Switches (Continued)

Connector/Switch Function

1000BT

100BT

10BT

Activity