Hardware reference guide

13. Reposition the subpanel (rotate it 90º), then snap it back into the bezel.
NOTE: Your computer may look different than the illustration shown below.
Figure 40 Changing from a Desktop to a Minitower Configuration
14. On the back of the Z200 Workstation front bezel, squeeze the HP logo mounting tabs (1) and press
the logo outward (2) as shown in the following illustration.
Figure 41 Rotating the Z200 Workstation Logo
Rotate the HP logo 90 degrees counterclockwise, and then release the logo and press it back into
place in the front bezel.
15. Replace the front bezel and computer access panel.
16. Reconnect the power cord and turn on the computer.
17. Lock any security devices that were disengaged when the computer access panel was removed.
36 Hardware Upgrades ENWW