Datasheet
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Authorized Service Provider parts
- Component replacement procedures
- Unlocking the device and disabling Always On Remote Management (select HP devices only)
- Bottom cover
- Display assembly components (panel, bezel, webcam, microphone)
- Keyboard
- SSD drive
- WLAN module
- Display assembly
- RTC battery
- Heat sink
- Battery
- Fingerprint reader board
- NFC module
- ForcePad (Touchpad)
- System board
- Power button
- Speaker assembly
- Component replacement procedures
- Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI) in Windows 8.1
- Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI) in Windows 7
- Using Setup Utility (BIOS) and HP PC Hardware Diagnostics (UEFI) in Ubuntu Linux
- Specifications
- Backup and recovery in Windows 8.1
- Backup and recovery in Windows 7
- Backing up, restoring, and recovering
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
2. Remove the WLAN antenna from the routing channel on the system board (1).
3. Remove the eight Phillips PM2.0×3.0 screws (2) that secure the system board to the computer.
4. Lift the right side of the system board up at an angle (1).
CAUTION: To avoid damaging or breaking the system board, use two hands when removing the board.
Do not lift up on the narrow end of the board.
5. Pull the flat ribbon cable through the slit in the system board (2).
Component replacement procedures 61