Datasheet
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Authorized Service Provider parts
- Component replacement procedures
- Unlocking the device and disabling Always On Remote Management (select HP devices only)
- Bottom cover
- Display assembly components (panel, bezel, webcam, microphone)
- Keyboard
- SSD drive
- WLAN module
- Display assembly
- RTC battery
- Heat sink
- Battery
- Fingerprint reader board
- NFC module
- ForcePad (Touchpad)
- System board
- Power button
- Speaker assembly
- Component replacement procedures
- Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI) in Windows 8.1
- Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI) in Windows 7
- Using Setup Utility (BIOS) and HP PC Hardware Diagnostics (UEFI) in Ubuntu Linux
- Specifications
- Backup and recovery in Windows 8.1
- Backup and recovery in Windows 7
- Backing up, restoring, and recovering
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
Heat sink
NOTE: The heat sink assembly spare part kit includes replacement thermal material.
Description Spare part number
Heat sink assembly 790073-001
Before removing the heat sink, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
Bottom cover on page 32).
5. Disconnect the battery cable.
Remove the heat sink:
1. Following the sequence stamped into the heat sink, loosen the four captive Philllips screws (1) that
secure the heat sink to the system board.
54 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts