Datasheet
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Authorized Service Provider parts
- Component replacement procedures
- Unlocking the device and disabling Always On Remote Management (select HP devices only)
- Bottom cover
- Display assembly components (panel, bezel, webcam, microphone)
- Keyboard
- SSD drive
- WLAN module
- Display assembly
- RTC battery
- Heat sink
- Battery
- Fingerprint reader board
- NFC module
- ForcePad (Touchpad)
- System board
- Power button
- Speaker assembly
- Component replacement procedures
- Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI) in Windows 8.1
- Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI) in Windows 7
- Using Setup Utility (BIOS) and HP PC Hardware Diagnostics (UEFI) in Ubuntu Linux
- Specifications
- Backup and recovery in Windows 8.1
- Backup and recovery in Windows 7
- Backing up, restoring, and recovering
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
SSD drive
Description Spare part number
Solid-state drive
512-GB 790057-001
256-GB, SED, OPAL2 790056-001
256-GB, TLC 804216-001
256-GB 790055-001
180-GB 790052-001
180-GB, SED, OPAL2 790053-001
128-GB, TLC 804215-001
128-GB 790051-001
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
Bottom cover on page 32).
5. Disconnect the battery cable.
Remove the SSD:
1. Remove the Phillips PM2.0×1.8 screw (1) that secures the drive to the system board.
Component replacement procedures 41