Datasheet
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures preliminary requirements
- Removal and replacement procedures for Authorized Service Provider parts
- Component replacement procedures
- Unlocking the device and disabling Always On Remote Management (select HP devices only)
- Bottom cover
- Display assembly components (panel, bezel, webcam, microphone)
- Keyboard
- SSD drive
- WLAN module
- Display assembly
- RTC battery
- Heat sink
- Battery
- Fingerprint reader board
- NFC module
- ForcePad (Touchpad)
- System board
- Power button
- Speaker assembly
- Component replacement procedures
- Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI) in Windows 8.1
- Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI) in Windows 7
- Using Setup Utility (BIOS) and HP PC Hardware Diagnostics (UEFI) in Ubuntu Linux
- Specifications
- Backup and recovery in Windows 8.1
- Backup and recovery in Windows 7
- Backing up, restoring, and recovering
- Statement of memory volatility
- Power cord set requirements
- Recycling
- Index
5. Disconnect the battery cable.
Remove the display assembly components:
1. Position the computer upright, and open as far as possible.
2. To remove the display bezel:
a. Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge (3) of
the display bezel until the bezel disengages from the display enclosure.
b. Remove the bezel.
The display bezel is available using spare part number 790046-001.
3. If it is necessary to replace the webcam/microphone module:
a. Detach the webcam/microphone module (1) from the display enclosure. (The webcam/
microphone module is attached to the display enclosure with adhesive.)
Component replacement procedures 35