User Manual

8/20q Fibre Channel Switch QuickTools switch management user guide 51
Operational State Switch operational state: Online, Offline, Diagnostic, Down
Administrative State Current switch administrative state
Configured Admin State Administrative state that is stored in the switch configuration
Beacon Status Beacon status. Switch LEDs are blinking (On) or not blinking
(Off).
Reason for Status The reason for the operational state.
Temperature Internal switch temperature °C
Power Supply 1 Status Whether the switch is On or Off
Temperature Failure Port
Shutdown
Non-configurable (always enabled for this switch). All ports
are shut down when the switch temperature exceeds the
Failure Temperature.
Warning Temperature Non-configurable temperature threshold (65° C), above
which a warning condition alarm is generated.
Failure Temperature Non-configurable temperature threshold (70° C), above
which a failure condition alarm is generated.
POST Status The current diagnostic state of the switch.
POST Fault Code The code value for the last recorded diagnostic test result
recorded on the switch.
Test Status The current diagnostic test status of switch.
Test Fault Code The code value for the last recorded diagnostic test status
recorded on the switch.
Network Group
IPv4 Enabled Internet Protocol version 4 Enabled or Disabled
IPv4 Address Internet Protocol version 4 address
IPv4 Subnet Mask Mask that determines the IP address subnet
IPv4 Gateway Gateway address
IPv6 Enabled Internet Protocol version 6 Enabled or Disabled
IPv6 Address Mask that determines the IP address subnet
IPv6 Gateway Gateway address
SNMP Enabled SNMP Enabled or Disabled
SNMP v3 Security Enabled SNMP v3 Security Enabled or Disabled
Broadcast Support Broadcast support status. Broadcast support is enabled
(default) or disabled.
NTP Client Enabled NTP Client Enabled or Disabled. If Enabled, this parameter
allows switches to synchronize their time to a centralized
server.
NTP Server Address The IP address of the centralized NTP server. Ethernet
connection to NTP server is required.
DNS Enabled Domain Name Service Enabled or Disabled
Table 9 Switch data window fields
Field Description