Owner's manual

4. To restore all configuration settings, click the Full Restore tab, then click Restore. To restore selected

configuration settings, click the Selective Restore tab, select one or more of the following options, and

then click Restore.

• Network Properties—Restores all settings presented in the Network properties dialog box except the

IP address. See ”Network properties” (page 65).

• IP Address—Restores switch IP address in addition to the other network properties.

• Port Properties—Restores all settings presented in the Port Properties dialog box. See ”Port symbolic

name” (page 98).

• Switch Properties—Restores all settings presented in the Switch properties dialog box except the

domain ID. See ”Switch properties” (page 61).

• Domain ID—Restores switch domain ID in addition to the other switch properties.

• Configured Zoning—Restores all configured zone sets, zones, and aliases in the switch’s zoning

database, excluding the active zone set.

• Nicknames—Restores the last saved nickname configuration.

• Call Home—Restores all Call Home configuration and profile settings.

5. If you select the Configured Zoning or Full Restore option and the file contains zone sets, a dialog box

prompts you to activate one of those zone sets. Click Yes, and then select a zone set from the

drop-down list in the Select Zoneset to be Activated dialog box.

6. Click OK and view the results in the top pane of the Restore dialog box.

Restoring the factory default configuration

You can restore the switch and port configuration settings to the factory default values. To restore the

factory configuration on a switch, select Switch > Restore Factory Defaults. The factory default switch

configuration settings are listed in Table 15.

Restoring the switch to the factory default configuration does not restore the account name and password

settings. The most current port license will remain in effect. To restore user accounts, you must select the

Reset User Accounts to Default option in the maintenance menu. See “Recovering a Switch” in the HP

SN6000 Fibre Channel Switch Installation and Reference Guide for your switch for information about

maintenance mode and the maintenance menu.

Table 15 Factory default configuration settings

Setting Value

Symbolic Name SN6000 FC Switch

Administrative State Online

Domain ID 1

Domain ID Lock False

In-band Management True

Broadcast Support Enable

Resource Allocation Timeout (R_A_TOV) 10000 milliseconds

I/O Stream Guard Auto

Device Scan Enabled True

Error Detect Timeout (E_D_TOV) 2000 milliseconds

SNMP Enabled True

SNMP Proxy True

IP Address 10.0.0.1

FDMI Enabled True