Hardware Reference Guide
Disconnecting power
1. Remove all removable media, such as optical discs or USB ash drives, from the computer.
2. Turn o the computer properly through the operating system, then turn o any external devices.
3. Disconnect the power cord from the AC outlet and disconnect any external devices.
Webcam
With Skype for Business installed on your external source device, you can use the webcam on the monitor in
the following ways:
● Stream online video conferences
● Maintain security over conversations
Webcam operation
1. To release the webcam, press it down to unlock it.
2. To close the webcam, press it down until it locks.
Setting up Windows Hello
If the Windows 10 operating system is installed on your computer, follow these steps to set up Windows Hello
facial recognition:
1. Select the Start button, select Settings, select Accounts, and then select Sign-in options.
2. Under Windows Hello, follow the on-screen instructions to add both a password and a 4-digit PIN. Then
enroll your ngerprint or facial ID.
Using the RFID reader (select models only)
Your computer supports radio frequency identication (RFID), which allows you to wirelessly share
information between a RFID tag or card and your computer. Information is transferred by tapping the tapping
area on the front bezel of the computer with your RFID tag or card. With RFID-enabled single sign-on
software, RFID allows you to sign in to your software application using the appropriate RFID card or tag.
NOTE: To locate the tapping area on your computer, see Front components on page 2. The RFID icon is lit
when the computer is turned on.
▲ To transfer information, tap the RFID tapping area on the front bezel of the computer with your RFID tag
or card.
To conrm that your RFID device is enabled, check the settings in BIOS (F10) Setup.
Computers or tablets with keyboards:
1. Turn on or restart the computer, and when the HP logo appears, press F10 to enter BIOS (F10) Setup.
2. Select Advanced, and then select Built-in Device Options.
3. Conrm that the check box for RFID is selected.
NOTE: To turn o the RFID reader, clear the check box.
4. To save your changes and exit BIOS (F10) Setup menus:
20 Chapter 2 Setup