Maintenance and Service Guide

3. Release the adhesive support strip (3) that secures the display panel cable to the system board.
4. Disconnect the display panel cable (4) from the system board.
5. Disconnect the speaker cable (5) from the system board.
6. Release the adhesive strip (6) that secure the speaker cable to the system board.
7. Remove the six Phillips M2.0×4.2 screws (1) that secure the system board to the base enclosure.
8. Remove the I/O bracket (2).
The I/O bracket is available using spare part number .
9. Lift the left side of the system board (3) until it rests at an angle.
42 Chapter 5 Removal and replacement procedures