Maintenance and Service Guide

7. Release the WLAN antenna main cable from the retention clips (8) and routing channel built into
the keyboard/top cover.
8. If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a. Swing the inside edge of the display bezel top edge (1) up and back until it releases from the display
back cover.
b. Swing the inside edges of the display bezel left and right edges (2) up and out until they release from
the display back cover.
CAUTION: When separating the bottom edge of the display bezel from the display back cover, make
sure not to damage the TouchScreen board (3).
c. Swing the inside edge of the display bezel bottom edge (4) up and out until it releases from
the display back cover.
Component replacement procedures 47