Quick Specs

QuickSpecs
HP Z6 G4 Workstation
System Technical Specifications
c05527761 — DA - 15955 Worldwide — Version 2 — November 1, 2017
Page 18
Memory Configuration
(Supported)
 Only Registered ECC DIMMs are supported.
 Do not install memory modules into memory slots if corresponding processor is not installed.
 Dual processor configurations with memory modules installed for only one processor is not
supported.
PCI Express Connectors
Slot 0:
Mechanical-only, for use with devices that require only rear bulkhead mounting or when 2
nd
CPU riser is
installed
Slot 1:
PCI Express Gen3 x4 - CPU with open-ended connector*
Slot 2:
PCI Express Gen3 x16 - CPU
Slot 3:
PCI Express Gen3 x4 - PCH with open-ended connector*
Slot 4:
PCI Express Gen3 x8 – CPU with open-ended connector (slot converts to x4 electrical when SSD is
installed in 2nd M.2 slot)*
Slot 5:
PCI Express Gen3 x16 - CPU
Slot 6:
PCI Express Gen3 x4 - PCH with open-ended connector*
M.2 Slot 1:
M.2 PCIe Gen 3 x4 - CPU up to 80mm storage devices
M.2 Slot 2:
M.2 PCIe Gen 3 x4 - CPU up to 80mm storage devices
* Open-ended connector allows a greater bandwidth (e.g. x16) card to be installed physically into a lower
bandwidth connector/slot.
Supported Drive
Interfaces
SATA
6 SATA @6Gb/s, supports RAID 0, 1 and NCQ.
Factory integrated RAID is Microsoft Windows only.
Serial Attached SCSI
Requires Optional PCIe card
Factory Configured
RAID
• RAID 0 configuration - striped array
• RAID 1 configuration - mirrored array
• RAID 10 striped and mirrored array
*HW RAID functionality not supported by Linux®. Use SW RAID functionality
provided in the Red Hat® Operating system instead.
Integrated Graphics
No
Network Controller
Integrated Intel® I219LM GbE LAN
Supports the following management functionalities: Intel® AMT11.2, TXT, DASH
1.1, WOL, VLAN, and PXE 2.1