Specifications

BEARING REPLACEMENT Document No. DER05017
Effective Date 25 May 07 Page 9 of 12
5. Install new small cross-section O-ring against shoulder of inboard pillow block cover, and slide
pillow block cover onto shaft.
6. Apply sufficient quantity of bearing grease listed in customer specification to completely cover
bearing rollers.
7. Slide assembled pillow block and bearing outer race onto inner race previously installed on
bearing journal.
8. Install new large cross-section O-ring against shoulder of outboard pillow block cover, slide
pillow block cover onto shaft, and rest against pillow block.
9. Orient inboard pillow block cover so that flat edge is aligned with bottom of pillow block.
TAPPING BEARING INTO PILLOW BLOCK
Figure 5017-6 Pillow Block Bearing Installation Details
10. Apply anti-seize compound to four flat head screws, and install screws to secure inboard
pillow block cover to pillow block. Tighten screws in accordance with
DER05018.
11. Orient outboard pillow block cover so that flat edge is aligned with bottom of pillow block.
12. Apply anti-seize compound to four flat head screws, and install screws to secure outboard
pillow block cover to pillow block and draw bearing into proper position within pillow block.
Tighten screws in accordance with
DER05018.
13. Slide outboard bearing flinger onto sheave, but leave screw loose.