Specifications

Document No. DER05017 BEARING REPLACEMENT
Page 6 of 12 Effective Date 25 May 07
Solids End Pillow Block Bearing (Cont’d)
5. Remove flathead screws securing outboard pillow block cover to pillow block, and remove
cover. Separate O-ring from pillow block cover and discard O-ring.
6. Remove flat head screws securing inboard pillow block cover to pillow block, and slide pillow
block and bearing outer race and rollers off solids bowl head.
7. Loosen set screw securing inboard flinger to solid bowl head.
8. Using a suitable puller and extreme care to avoid damaging bearing seat or shoulder on solid
bowl head, remove bearing inner race from bowl head. Discard inner race.
9. Slide inboard pillow block cover and flinger off bowl head. Separate O-ring from pillow block
cover and discard O-ring.
10. Using a suitable puller, remove bearing outer race and rollers from pillow block. Discard outer
race and rollers.
Figure 5017-5 Solids End Cross Section