Specifications

Document No. DER03020 INSTALLATION INSTRUCTIONS

Page 6 of 7 Effective Date 10 Oct 08

ELECTRIC POWER CONNECTIONS (CONT’D)

Figure 3020-5 Electric Power and Feed Pump Connections

MACHINE STARTUP

Refer to Section 4 of this manual for initial startup and operating procedures for the centrifuge.

WARNING! DO NOT ATTEMPT TO OPERATE MACHINE WITH SHIPPING

COMPONENTS INSTALLED.

The content of this document is subject to change at any time. Information provided does not cover all details or variations possible

with DERRICK equipment; nor does it cover every contingency that may be met during installation, operation, maintenance, or

troubleshooting of the equipment. If additional information is required, or should situations arise that are not covered by this manual,

bring the matter to the attention of your local DERRICK representative or the Service Department at DERRICK Corporation in

Buffalo, New York.