Specifications

Document No. DER01320

Effective Date 10 Oct 08

Supersedes 25 May 07

Page No. 1 of 1

SERVICES & UTILITIES REQUIRED

DE-1000 CENTRIFUGE - GEARBOX DRIVE

GENERAL

To achieve optimum performance and reliability from your Derrick equipment, the services and

utilities described below must be available at the installation site.

ELECTRIC POWER

For electrical service requirements, refer to the voltage label inside the electrical junction box.

Also consult the data plate on the drive motor housing to verify power requirements. Refer to

Section 11 - Reference Drawings for the wiring schematic that applies to the centrifuge.

WARNING! THE EQUIPMENT WILL BE DAMAGED BY INCORRECT ELECTRIC

POWER. BE CERTAIN THAT POWER SUPPLIED TO THE EQUIPMENT IS THE

CORRECT VOLTAGE AND FREQUENCY.

FEED PUMP

The customer must supply a positive-displacement feed pump of up to 15 HP for delivering slurry

to the centrifuge. The pump must be connected to the centrifuge’s electrical control system as

described in DER03020 so that its operation can be supervised by the centrifuge.

The content of this document is subject to change at any time. Information provided does not cover all details or variations possible

with DERRICK equipment, nor does it cover every contingency that may be met in conjunction with installation, operation,

maintenance, or troubleshooting of the equipment. Should additional information be required, or should situations arise that are not

covered by this manual, bring the matter to the attention of your local DERRICK representative or the Service Department at

DERRICK Corporation in Buffalo, New York.