Installation Manual

Unit Installation ProCurve Secure Router Installation Guide

Installing the Encryption Module

The Encryption Module slot supports the 7100/7200 IPSec Module. All software options associated with the

card become available once the card is installed. Follow these cautions and steps when installing a module.

Installing a CompactFlash

Card

The Compact Flash slot supports any Type 1 CompactFlash

card (16 MB to 1 GB). Follow these

instructions when installing the card.

T1/E1 Mode Dip-Switch

The ProCurve Secure Router dl 8x T1/E1 Wide Module is shipped with the T1/E1 mode switch (located on

the circuit board) set to T1 (in the 1 position). If you require E1 functionality, use your thumbnail to slide

the switch to the

ON position (as shown in the figure below).

Caution

Always remove power from the unit prior to removing or installing a module.

Improper installation may result in damage to the modules.

Instructions for Installing the Encryption Module

1 Remove power from the unit.

2 Remove the blank cover plate from the Encryption Module slot.

3 Slide the module into the Encryption Module slot until the module is firmly seated against the

chassis.

4 Secure the screws at both edges of the module.

5 Restore power to the unit.

6 The configuration options for encryption will now be available in the GUI and the SROS CLI.

Note

The CompactFlash

card is hot-swappable and can be inserted or removed while power is

applied to the unit.

Instructions for Installing a CompactFlash

Card

1 Slide the module into the Compact Flash slot until the card is firmly seated against the

chassis.

The CompactFlash

options will now be available in the GUI and the SROS CLI.

Switch Set to E1 Mode

Switch Set to T1 Mode