Installation Manual

ProCurve Secure Router Installation Guide Option Modules
5990-3760 Copyright 2006 Hewlett-Packard Development Company, LP 27
1xADSL2+ Annex B Interface Module
The 1xADSL2+ Annex B Interface Module (see Figure 13) adds ADSL capability to the ProCurve Secure
Router. Performance information is provided below. Refer to Table A-9 on page 46 for the pinouts. Refer
to Table A-12 on page 47 for the backup connector pinouts. An optional backup module is required for
backup applications.
Figure 13. 1xADSL2+ Annex B Interface Module
Features and Specifications
ADSL Interface
• ADSL over ISDN, Annex B
• Supported Standards:
– ITU G.992.1 – Annex B (G.dmt)
• RJ-11C (6-pin jack, inner pair)
ATM
• Multiple Protocol over AAL5 (RFC2684)
• ATM Forum UNI 3.1/4.0 PVC
• Up to 16 Virtual Circuits
• ATM Class of Service (UBR)
• PPP over ATM (RFC2364)
• PPP over Ethernet (RFC2516)
•ATM F5 OAM
Compliance
• EN 60950, IEC 60950
• EMC - see Electromagnetic Compatibility
(EMC) Table on page 62
Physical
• Dimensions: 6.99 cm (2.75 in) W x
10.80 cm (4.25 in) D
ADSL1 Performance
• Max = 8 Mbps downstream and
800 kbps upstream
• Min = 224 kbps downstream and
32 kbps upstream
ADSL2 Performance
• Max = ~12 Mbps downstream and
~1 Mbps upstream
• Min = 224 kbps downstream and
32 kbps upstream
ADSL2+ Performance*
• Max = ~24.5 Mbps downstream and up to
2 Mbps upstream
• Min = 224 kbps downstream and 32 kbps
upstream
*ADSL2+ support is planned in a future software update.
Environmental
• Operating temperature: 0°C to 50°C (32°F
to 122°F)
• Non-Operating Temperature: -20°C to
70°C (-4°F to 158°F)
• Relative Humidity: Up to 95 percent
noncondensing at 30°C (86°F)
• Non-Operating Relative Humidity: Up to
95 percent noncondensing at 30°C (86°F)
• Altitude: Up to 3.05 km (10,000 ft)