Installation Manual

ManualsBrandsHP ManualsRoutersHP 7000 dl Router Series

Physical Description ProCurve Secure Router Installation Guide

Console Interface

The Console interface is an EIA-232 serial port (DTE) which provides for local management and

configuration (via a DB-9 female connector). Table A-1 on page 43 shows the

Console port pinouts.

10/100BaseT Ethernet Interface and Activity LEDs

The Ethernet ports (Eth 0/1, Eth 0/2) are RJ-45 connectors with LEDs. The yellow activity LED flashes

when data traffic is being sent or received on the Ethernet port. The green link LED is on when the router

has a good connection to the LAN. Refer to Table A-2 on page 43 for the Ethernet port pinouts. The

Ethernet port provides the following:

• 10BaseT or 100BaseT with a single connector

• Auto-negotiation

•CSMA/CD

• IEEE 802.3 compatibility

• Auto-MDIX

Module Card Slots

The module card slots support various network plug-in cards. These card options are described in the

section Option Modules on page 18.

Slot 1/Slot 2 -

Bkp

Off No backup module is installed.

Green (solid)

Backup module is ready. For the ISDN BRI backup module, green solid

indicates that the negotiation with the switch is complete.

Green (flashing) Backup is active.

Red (solid)

An alarm condition is occurring on the backup interface, or there is a

self-test failure. An interface is configured and in the “no shutdown”

condition, but a valid physical network connection has not yet been

established.

Yellow (solid) Unit is in test.

Slot 1/Slot 2 - Tx/

Off There is no activity on the WAN or backup interface.

Green (flashing) There is activity on the WAN or backup interface.

Slot 3 - Stat

(7203dl only)

Off Module is not installed.

Green (solid) Module is recognized by the system.

Red (solid) An alarm condition is occurring on the module interface.

Slot 3 - Act

(7203dl only)

Off There is no data activity on the module.

Green (flashing) There is data activity on the module.

Slot 3 - Test

(7203dl only)

Off Module is not in test.

Yellow (solid) Module is in test mode.

ETH 0/1 -

Link

Off 10/100BaseT Ethernet connection is inactive.

Green (solid) 10/100BaseT Ethernet connection is active.

ETH 0/2 -

Activity

Off No Tx or Rx data is present.

Yellow (flashing) Tx or Rx data is present.

Note

Connection directly to an external modem requires a straight-through cable.

Table 1. ProCurve Secure Router LEDs (Continued)

LED Color Indicates that…