Command Reference Guide

Common Commands
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 929
end
Use the end command to exit the current Configuration Mode and enter the Enable Security Mode.
Syntax Description
No subcommands.
Default Values
No defaults necessary for this command.
Command Modes
This command is valid for all command modes except the Enable Security Mode.
Usage Examples
The following example shows the end command being executed in the T1 Configuration Mode:
(config-t1 1/1)#
end
#
#- Enable Security Mode command prompt
Note
When exiting the Global Configuration Mode, remember to perform a copy running-config
startup-config to save all configuration changes.